DBS Agitator-Pump is designed with a thermal cutting housing to protect the ball bearings from dampness. A fan is installed inside in order to cool the motor and to decrease the lower bearing temperature which is the part most subject to strain. These measures together with the energy saving motor, guarantee a greater life expectancy of the pump.
>> Request Technical Details
>> Power cords available
>> Technical specification
Technical specification
Pump |
AGITATOR-PUMP with immersed vertical axis. |
Windings | Single-phase motor with Class F. |
Motor body | Casing in extruded aluminium. |
Protection | IP54 degree of protection from liquids seepage. |
Safety | Built-in thermal motor protection system. |
Ball bearings | Ø 8mm NSK, SKF or equivalent, in semi-rigid and noise-insulated silicone casing. |
Motor shaft | AISI 303 INOX steel Ø 8mm. |
Fastening parts | INOX steel or anti-oxidant materials. |
Motor parts | Thermoplatic motor parts resistant to high temperature. |
Cooling system | Air cooled pump with a suction speed of 3,1 meter/second. |
Water connection | Compatible with John Guest fittings. |
Operation | Power supply 220 & 230Volts – 24 hours a day non stop. |
Regulations | Complying to EN60335-2-41 and WEEE/RoHs directives. |
Note | PATENDED device. Read the instruction booklet for a correct set up and use. |
![dbs-grafico](http://www.saberpumps.com/wp-content/uploads/2013/04/dbs-grafico.png)
TYPE | Volt | Hz | Amp | Watt | Rpm | A | B | C | Propeller Ø (mm) | Weight |
DBS-6 | 230 | 50 | 0,15 | 38 | 2800 | 82 | 190 | 78 | 50 2 Blades 15° | 1,60 |
DBS-7 | 230 | 50 | 0,16 | 43 | 2800 | 82 | 190 | 90 | 50 2 Blades 15° | 1,70 |
Performance and electrical data has been tested at 0°C with clean water only.